Sarpy soil
Wild-clay potential
Weak indication
Weak indication: no layer of Sarpy shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sarpy soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Sarpy loamy fine sand, 0 to 2 percent slopes, frequently flooded, long duration (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 50 in (127 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A loamy fine sand layer about 0 to 10 in down: about 5% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH2best layer A sand layer about 10 to 60 in down: about 3% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 10 to 60 in down in the typical profile: grayish brown (10YR 5/2); loose. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: not used.
- Drainage: excessively drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Physiographic Division--Interior Plains
USDA, geographic setting: Parent material--sandy alluvium
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sarpy loamy fine sand, 0 to 2 percent slopes, frequently flooded, long duration, map unit 3092L in Pike County, Illinois.
- Official Series Description: Sarpy(revised 10/2004), established.
- Taxonomic class: Mixed, mesic Typic Udipsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.