San Andreas soil
Wild-clay potential
Weak indication
Weak indication: no layer of San Andreas shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about San Andreas soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a San Andreas spot on the map
Rated from the USDA soil survey record for San Andreas sandy loam, 15 to 30 percent slopes, warm MAAT, MLRA 20 (Orange County and Part of Riverside County, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Note Moderate engineering plasticity index (8).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- Sandy layerH1best layer A sandy loam layer about 0 to 31 in down: about 13% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockH2 Bedrock about 31 to 39 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H1), 0 to 31 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 31 in (79 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in California, in these survey areas: Orange County and Part of Riverside County, California.
By state: wild clay in California.
USDA, distribution and extent: Along the coast from San Francisco to Santa Barbara in California, MLRA 15. The series is of moderate extent.
USDA, geographic setting: San Andreas soils are on hills and mountainous uplands at elevations of 200 to 2,500 feet. Slopes are 9 to 75 percent. The climate is subhumid with rainless but somewhat foggy summers and cool moist winters. Mean annual precipitation, all in the form of rain, is about 12 to 35 inches. Average January temperature is about 50 degrees F, average July temperature is about 64 degrees F., mean annual temperature is 57 to 65 degrees F. The average frost-free season is about 200 to 350 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alo: Strong lead
- Bosanko: Strong lead
- Cropley: Strong lead
- Myford: Strong lead
- Omni: Strong lead
- Rincon: Strong lead
- Zaca: Strong lead
- Balcom: Promising
See it on the map
Open a San Andreas spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for San Andreas sandy loam, 15 to 30 percent slopes, warm MAAT, MLRA 20, map unit 193 in Orange County and Part of Riverside County, California.
- Official Series Description: San Andreas(revised 06/1999), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, thermic Typic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.