Myford soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 12 to 18 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Myford soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Myford sandy loam, 2 to 9 percent slopes (Orange County and Part of Riverside County, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 40% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (28): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 6 in (16 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 6.4%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA1 A sandy loam layer about 0 to 1 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- TopsoilA2 A sandy loam layer about 1 to 4 in down: about 8% clay, low plasticity when wet, pinkish-gray when moist. Weak indication
- TopsoilA3 A sandy loam layer about 4 to 12 in down: about 8% clay, low plasticity when wet, pinkish-gray when moist. Weak indication
- Clay subsoilBt1best layer A sandy clay layer about 12 to 18 in down: about 40% clay, high plasticity when wet, brown when moist. Strong lead
- Clay subsoilBt2 A sandy clay loam layer about 18 to 28 in down: about 25% clay, moderate plasticity when wet, brown when moist. Possible
- Clay subsoilBtk1 A sandy clay loam layer about 28 to 35 in down: about 25% clay, moderate plasticity when wet, brown when moist. Possible
- Clay subsoilBtk2 A sandy clay loam layer about 35 to 41 in down: about 25% clay, moderate plasticity when wet, light-brown when moist. Possible
- Loamy layerB't1 A sandy clay loam layer about 41 to 49 in down: about 25% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerB't2 A sandy clay loam layer about 49 to 61 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt3 A sandy clay loam layer about 61 to 71 in down: about 25% clay, moderate plasticity when wet, light-brown when moist. Weak indication
- Sandy layerC A sandy loam layer about 71 to 79 in down: about 12% clay, moderate plasticity when wet, very pale-brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 12 to 18 in down in the typical profile: brown (7.5YR 4/2), dark brown (7.5YR 3/2); when; extremely hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 9 map units in California, in these survey areas: Los Angeles County, California, Southeastern Part; Orange County and Part of Riverside County, California.
By state: wild clay in California.
USDA, distribution and extent: Southern California. The series is of moderate extent in MLRA 19.
USDA, geographic setting: Myford soils are nearly level to moderately steep and are on terraces at elevations of less than 1,500 feet. The climate is dry subhumid mesothermal with dry summers and cool moist winters. Mean annual precipitation is 12 to 20 inches. Mean annual temperature is about 62 degrees F.; average January temperature is about 53 degrees F.; average July temperature is about 70 degrees F. The frost-free season is 270 to 350 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cropley: Strong lead
- Zaca: Strong lead
- Alo: Strong lead
- Bosanko: Strong lead
- Omni: Strong lead
- Rincon: Strong lead
- Balcom: Promising
- Blasingame: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Myford sandy loam, 2 to 9 percent slopes, map unit 173 in Orange County and Part of Riverside County, California.
- Official Series Description: Myford, established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Typic Palexeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.