Cropley soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 2 to 14 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cropley soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cropley spot on the map
Rated from the USDA soil survey record for Cropley clay, 0 to 2 percent slopes, warm MAAT, MLRA 19 (Orange County and Part of Riverside County, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (33): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 8.6%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerAp A clay layer about 0 to 2 in down: about 45% clay, high plasticity when wet, very dark gray when moist. Promising
- Clay-rich layerBss1best layer A clay layer about 2 to 14 in down: about 45% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBss2 A clay layer about 14 to 22 in down: about 45% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBk1 A clay layer about 22 to 28 in down: about 45% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBk2 A silty clay loam layer about 28 to 40 in down: about 35% clay, high plasticity when wet, dark gray when moist. Strong lead
- Loamy layerBk3 A silt loam layer about 40 to 60 in down: about 20% clay, moderate plasticity when wet, dark gray when moist. Possible
What it looks like raw
The clay-rich layer (Bss1), 2 to 14 in down in the typical profile: dark gray (2.5Y 4/1) broken face, black (2.5Y 2.5/1) broken face; hard, firm, very sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from calcareous shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in California, in these survey areas: Los Angeles County, California, Southeastern Part; Orange County and Part of Riverside County, California.
By state: wild clay in California.
USDA, distribution and extent: The soils are moderately extensive and are mapped in MLRA?s 14 and 19.
USDA, geographic setting: Cropley soils are on alluvial fans, floodplains and in small basins. Slopes are smooth and are 0 to 15 percent. Cropley soils formed in fine textured alluvium weathered from shale, sandstone and mudstone. Elevation is 10 to 2100 feet. The climate is dry subhumid mesothermal with warm dry summers and cool moist winters. Mean annual precipitation is 12 to 30 inches. The mean annual temperature is 57 to 62 degrees F. Average January temperature is about 49 degrees F. in most areas, but is about 56 degrees F. close to the coast of California; average July temperatures is about 68 degrees f. Frost free season is 200 to 330 days and up to 360 days along the coast.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Myford: Strong lead
- Zaca: Strong lead
- Alo: Strong lead
- Bosanko: Strong lead
- Omni: Strong lead
- Rincon: Strong lead
- Balcom: Promising
- Blasingame: Promising
See it on the map
Open a Cropley spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cropley clay, 0 to 2 percent slopes, warm MAAT, MLRA 19, map unit 148 in Orange County and Part of Riverside County, California.
- Official Series Description: Cropley(revised 11/2009), established.
- Taxonomic class: Fine, smectitic, thermic Aridic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.