Safety soil
Wild-clay potential
Weak indication
Weak indication: no layer of Safety shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Safety soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Safety stony sandy loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 22% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A stony ashy sandy loam layer about 0 to 3 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 An ashy sandy loam layer about 3 to 11 in down: about 8% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A sandy loam layer about 11 to 24 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- BedrockH4 Weathered bedrock about 24 to 34 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 11 to 24 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; soft, very friable, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from granite mixed with volcanic ash and loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 24 in (61 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in the northern portion of Chelan County, Washington. Series is of small extent.
USDA, geographic setting: Safety soils are on mountain sideslopes that generally have southerly aspects. Slopes are 8 to 90 percent. They are formed in loess and volcanic ash mixed with residuum from granitic rock. Elevations are 1,700 to 3,800 feet. The climate is characterized by warm, dry summers and cool, moist winters. The average annual precipitation is about 15 to 25 inches. The average January temperature is about 26 degrees F.; average July temperature is about 68 degrees F.; average annual temperature is about 46 to 48 degrees F. The growing season at 28 degrees is 140 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Safety stony sandy loam, 30 to 60 percent slopes, map unit 248 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Safety(revised 07/2001), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.