Raynham soil
Wild-clay potential
Weak indication
Weak indication: no layer of Raynham shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Raynham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Raynham spot on the map
Rated from the USDA soil survey record for Raynham silt loam, 0 to 6 percent slopes (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 50 in (127 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 6 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 6 to 22 in down: about 10% clay, low plasticity when wet, olive gray when moist. Weak indication
- Sandy layerH3best layer A silt loam layer about 22 to 72 in down: about 10% clay, low plasticity when wet, olive gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 22 to 72 in down in the typical profile: olive gray (5Y 5/2), and dark grayish brown (2.5Y 4/2); friable. Raw colour is not fired colour.
About the soil
- Parent material: coarse-silty glaciolacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Vermont, in these survey areas: Addison County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: Vermont, Connecticut, Massachusetts, New Hampshire, New Jersey, and New York. MLRA's 101, 139, 140, 142, 144A, 145, and 149B. The series is of large extent.
USDA, geographic setting: The Raynham soils are level through strongly sloping soils on lake plains and marine terraces. They are in depressions and drainageways and on side slopes of swells and knolls. Slope ranges from 0 through 12 percent. The soils formed in silty estuarine, marine or glaciolacustrine deposits. The mean annual precipitation ranges from 30 through 50 inches (762 through 1270 millimeters) and the mean annual temperature ranges from 45 through 52 degrees F. (7 through 11 degrees C.) The frost-free season ranges from 105 through 240 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Covington: Strong lead
- Livingston: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Elmwood: Promising
- Canandaigua: Possible
- Farmington: Possible
See it on the map
Open a Raynham spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Raynham silt loam, 0 to 6 percent slopes, map unit RaB in Addison County, Vermont.
- Official Series Description: Raynham(revised 03/2010), established.
- Taxonomic class: Coarse-silty, mixed, active, nonacid, mesic Aeric Epiaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.