Petrolia soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 33 to 80 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Petrolia soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Petrolia spot on the map
Rated from the USDA soil survey record for Petrolia silt loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 46 in (118 cm)).
- Note Typically starts about 33 in (85 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 11 in down: about 25% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerH2 A silty clay loam layer about 11 to 33 in down: about 31% clay, high plasticity when wet, gray when moist. Promising
- Loamy layerH3best layer A silty clay loam layer about 33 to 80 in down: about 31% clay, high plasticity when wet, gray when moist. Promising
What it looks like raw
The loamy layer (H3), 33 to 80 in down in the typical profile: gray (2.5Y 6/1); firm. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Southern and south-central Illinois, and southwestern Indiana in MLRAs 113, 114B, 115A, 115B and 115C. Extent is large (slightly more than 100,000 acres correlated).
USDA, geographic setting: Petrolia soils are on nearly level or slightly depressional parts of flood plains or on flooded parts of glacial lake plains. Slopes range from 0 to 2 percent. Petrolia soils formed in light colored, moderately fine textured or medium textured alluvium. Mean annual air temperature ranges from 11 to 14 degrees C (52 to 57 degrees F.), mean annual precipitation ranges from 965 to 1219 millimeters (38 to 48 inches), frost free days range from 180 to 200, and elevation ranges from 104 to 152 meters (340 to 500 feet) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Open a Petrolia spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Petrolia silt loam, 0 to 2 percent slopes, occasionally flooded, map unit 8288A in Pike County, Illinois.
- Official Series Description: Petrolia(revised 04/2011), established.
- Taxonomic class: Fine-silty, mixed, superactive, nonacid, mesic Fluvaquentic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.