Pemi soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pemi shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pemi soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pemi silt loam, 0 to 5 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 44 in (112 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 5 in down, not a clay body. Weak indication
- Sandy layerH1 A silt loam layer about 5 to 14 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A very fine sandy loam layer about 14 to 21 in down: about 10% clay, low plasticity when wet, light olive gray when moist. Weak indication
- Sandy layerH3best layer A stratified silt loam layer about 21 to 65 in down: about 10% clay, low plasticity when wet, light olive gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 21 to 65 in down in the typical profile: light olive gray (5Y 6/2); friable. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New Hampshire, in these survey areas: Coos County Area, New Hampshire.
By state: wild clay in New Hampshire.
USDA, distribution and extent: New Hampshire and possibly Vermont; MLRA 143 and 144B. The series is of limited extent.
USDA, geographic setting: Pemi soils are on nearly level to gently sloping terraces or lake plains. Slope ranges from 0 to 8 percent. They formed in medium textured lacustrine sediments of Wisconsin age. Mean annual precipitation ranges from 35 to 45 inches, and mean annual air temperature ranges from 40 to 47 degrees F. The growing season ranges from 80 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abenaki: Weak indication
- Adams: Weak indication
- Becket: Weak indication
- Berkshire: Weak indication
- Bucksport: Weak indication
- Charles: Weak indication
- Cohas: Weak indication
- Colton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pemi silt loam, 0 to 5 percent slopes, map unit 633A in Coos County Area, New Hampshire.
- Official Series Description: Pemi, established.
- Taxonomic class: Coarse-silty, mixed, active, nonacid, frigid Typic Epiaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.