Palmont soil
Wild-clay potential
Weak indication
Weak indication: no layer of Palmont shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Palmont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Palmont spot on the map
Rated from the USDA soil survey record for Palmont very stony fine sandy loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 35 in (88 cm)).
- Note Typically starts about 25 in (64 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 48% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A very stony ashy fine sandy loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerH2 A cobbly ashy sandy loam layer about 3 to 10 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerH3 A very stony coarse sandy loam layer about 10 to 25 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerH4best layer A very gravelly loamy sand layer about 25 to 60 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (H4), 25 to 60 in down in the typical profile: light gray (10YR 7/2), light brownish gray (10YR 6/2) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium from rhyolite and granodiorite, with a mantle of volcanic ash and pumice.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: Central Chelan County, Washington. Series is of small extent.
USDA, geographic setting: Palmont soils are on mountainsides that generally have a north aspect. Slopes are 30 to 90 percent. These soils formed in colluvium from rhyolite and granodiorite with a mantle of volcanic ash and pumice. Elevations are 2,200 to 5,300 feet. The climate is characterized by warm, dry summers and cold, moist winters. The average annual precipitation is 25 to 35 inches. The average January temperature is 42 degrees F., average July temperature is 65 degrees F., average annual air temperature is about 42 degrees F. The frost-free season is 80 to 110 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Palmont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Palmont very stony fine sandy loam, 30 to 60 percent slopes, map unit 228 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Palmont(revised 01/2000), tentative.
- Taxonomic class: Sandy-skeletal, mixed, frigid Andic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.