Palmich soil
Wild-clay potential
Weak indication
Weak indication: no layer of Palmich shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Palmich soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Palmich spot on the map
Rated from the USDA soil survey record for Palmich cindery sandy loam, 15 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 35% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A paragravelly ashy sandy loam layer about 0 to 4 in down: about 8% clay, low plasticity when wet. Weak indication
- Sandy layerH2 A very paragravelly ashy sandy loam layer about 4 to 15 in down: about 8% clay, low plasticity when wet. Weak indication
- Sandy layerH3 A very paragravelly ashy sandy loam layer about 15 to 26 in down: about 10% clay, low plasticity when wet. Weak indication
- Sandy layerH4best layer An extremely paragravelly ashy sandy loam layer about 26 to 44 in down: about 10% clay, low plasticity when wet. Weak indication
- Sandy layerH5 A very gravelly sandy loam layer about 44 to 60 in down: about 9% clay, low plasticity when wet. Weak indication
What it looks like raw
The sandy layer (H4), 26 to 44 in down in the typical profile: soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and pumice over colluvium from granodiorite or rhyolite.
- USDA family particle-size class: ashy-pumiceous.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in East Central Chelan County, Washington; MLRA 6. Series is of small extent.
USDA, geographic setting: Palmich soils are on foot slopes, back slopes and ridgetops of mountains and have slopes of l5 to 90 percent. Elevation is 2,300 to 5,200 feet. These soils formed in volcanic ash and pumice over colluvium mostly from granodiorite or rhyolite and some from gneiss and schist. These soils are in a climate with warm, dry summers and cool, moist winters. The mean annual precipitation is 25 to 35 inches. The mean January temperature is about 24 degrees F, the mean July temperature is about 66 degrees F, and the mean annual temperature is about 42 to 44 degrees F. The growing season at 28 degrees F is about l40 to l70 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Palmich spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Palmich cindery sandy loam, 15 to 30 percent slopes, map unit 220 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Palmich(revised 02/2001), established.
- Taxonomic class: Ashy-pumiceous, glassy, frigid Typic Vitrixerands
- Rated with rule version 2026-09-28.1; the method is on the About page.