Ormas soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ormas shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ormas soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ormas loamy sand, 0 to 2 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 17% clay.
- Note USDA labels this a "Bt1,2Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts about 34 in (86 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 28% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A loamy sand layer about 0 to 10 in down: about 4% clay, low plasticity when wet. Weak indication
- Sandy layerE1 A loamy sand layer about 10 to 22 in down: about 3% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerE2 A sand layer about 22 to 34 in down: about 4% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt1,2Bt2best layer A gravelly coarse sandy loam layer about 34 to 48 in down: about 17% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layer2C1 A gravelly coarse sand layer about 48 to 52 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layer2C2 A gravelly coarse sand layer about 52 to 60 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1,2Bt2), 34 to 48 in down in the typical profile: dark yellowish brown (10YR 4/4); firm. Raw colour is not fired colour.
About the soil
- Parent material: sandy over loamy outwash over sandy and gravelly outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 97, 98, 111B, 111C, and 111D in northern Indiana and southern Michigan. The type location is in MLRA 111B. The series is of large extent.
USDA, geographic setting: Ormas soils are on high terraces or uplands with a plane or convex surface. Slope ranges from 0 to 25 percent. Ormas soils formed in wind reworked sandy outwash. Mean annual precipitation ranges from 762 to 1067 mm (30 to 42 inches). Mean annual temperature ranges from 8.9 to 11.7 degrees C (48 to 53 degrees F). Frost-free period is 130 to 180 days. Elevation is 177 to 466 meters (580 to 1,530 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ormas loamy sand, 0 to 2 percent slopes, map unit OrA in Kosciusko County, Indiana.
- Official Series Description: Ormas(revised 11/2021), established.
- Taxonomic class: Loamy, mixed, active, mesic Arenic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.