Oak level soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 7 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Oak level soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Oak level spot on the map
Rated from the USDA soil survey record for Oak Level loam, dark surface, 2 to 6 percent slopes (Forsyth County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (31.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- TopsoilA1 A loam layer about 0 to 7 in down: about 17% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Clay-rich layerB2best layer A clay layer about 7 to 30 in down: about 50% clay, high plasticity when wet, red when moist. Strong lead
- Loamy layerBC3 A clay loam layer about 30 to 36 in down: about 30% clay, moderate plasticity when wet, yellowish red when moist. Promising
- Loamy layerC3 A clay loam layer about 36 to 80 in down: about 28% clay, moderate plasticity when wet, yellowish red when moist. Possible
What it looks like raw
The clay-rich layer (B2), 7 to 30 in down in the typical profile: red (2.5YR 4/8); firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite derived from diorite and/or gabbro and/or diabase and/or gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in North Carolina, in these survey areas: Forsyth County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: Virginia and North Carolina
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Banister: Strong lead
- Casville: Strong lead
- Cecil: Strong lead
- Clifford: Strong lead
- Enon: Strong lead
- Fairview: Strong lead
- Hiwassee: Strong lead
See it on the map
Open a Oak level spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Oak Level loam, dark surface, 2 to 6 percent slopes, map unit OkB in Forsyth County, North Carolina.
- Official Series Description: Oak level(revised 06/2026), established.
- Taxonomic class: Fine, mixed, active, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.