Fairview soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 9 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fairview soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fairview spot on the map
Rated from the USDA soil survey record for Fairview sandy loam, 2 to 8 percent slopes (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (12).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilA A sandy loam layer about 0 to 5 in down: about 14% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilAB A sandy loam layer about 5 to 9 in down: about 14% clay, low plasticity when wet, strong brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 9 to 28 in down: about 50% clay, moderate plasticity when wet, red when moist. Strong lead
- Loamy layerBC A sandy clay loam layer about 28 to 38 in down: about 23% clay, low plasticity when wet, red when moist. Weak indication
- Sandy layerC A sandy loam layer about 38 to 80 in down: about 18% clay, low plasticity when wet, red when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 9 to 28 in down in the typical profile: red (2.5YR 4/8) broken face; clay; firm, slightly sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite derived from granite and gneiss and/or schist.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 15 map units in North Carolina, in these survey areas: Davidson County, North Carolina; Forsyth County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: Virginia and North Carolina
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Casville: Strong lead
- Cecil: Strong lead
- Clifford: Strong lead
- Enon: Strong lead
- Mecklenburg: Strong lead
- Nathalie: Strong lead
- Pacolet: Strong lead
See it on the map
Open a Fairview spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 84%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fairview sandy loam, 2 to 8 percent slopes, map unit FaB in Davidson County, North Carolina.
- Official Series Description: Fairview(revised 05/2026), established.
- Taxonomic class: Fine, kaolinitic, mesic Typic Kanhapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.