Clifford soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 6 to 35 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Clifford soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Clifford spot on the map
Rated from the USDA soil survey record for Clifford sandy loam, 2 to 8 percent slopes (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 54% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (39): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 29 in (74 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 6 in down: about 13% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Clay subsoilBt1best layer A clay layer about 6 to 35 in down: about 54% clay, high plasticity when wet, percent red when moist. Strong lead
- Clay subsoilBt2 A clay loam layer about 35 to 55 in down: about 38% clay, high plasticity when wet, red when moist. Strong lead
- Loamy layerC A loam layer about 55 to 80 in down: about 19% clay, moderate plasticity when wet, percent red when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 6 to 35 in down in the typical profile: percent red (2.5YR 4/6), percent red (2.5YR4/8); clay loam; friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite residuum weathered from granite and gneiss and/or saprolite residuum weathered from schist.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 10 map units in North Carolina, in these survey areas: Davidson County, North Carolina; Forsyth County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: Virginia and North Carolina
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Casville: Strong lead
- Cecil: Strong lead
- Enon: Strong lead
- Fairview: Strong lead
- Mecklenburg: Strong lead
- Nathalie: Strong lead
- Pacolet: Strong lead
See it on the map
Open a Clifford spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 93%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Clifford sandy loam, 2 to 8 percent slopes, map unit CrB in Davidson County, North Carolina.
- Official Series Description: Clifford(revised 01/2006), established.
- Taxonomic class: Fine, kaolinitic, mesic Typic Kanhapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.