Natapoc soil
Wild-clay potential
Weak indication
Weak indication: no layer of Natapoc shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Natapoc soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Natapoc spot on the map
Rated from the USDA soil survey record for Natapoc stony sandy loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A stony ashy loam layer about 0 to 6 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH2 An ashy sandy loam layer about 6 to 19 in down: about 8% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH3best layer A very bouldery sandy loam layer about 19 to 60 in down: about 6% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 19 to 60 in down in the typical profile: light gray (2.5Y 7/2), dark grayish brown (2.5Y 4/2) moist; hard, firm, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over glacial till.
- USDA family particle-size class: ashy over loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, geographic setting: Natapoc soils are on toe slopes and back slopes of mountains at elevations of 1,500 to 2,400 feet. Slopes range from 3 to 60 percent. Natapoc soils formed in volcanic ash over glacial till. They are in a climate of warm, dry summers and cool, moist winters. The average January temperature is about 23 degrees F, the average July temperature is about 64 degrees F, and the average annual temperature is 40 to 44 degrees F. The average annual precipitation is 18 to 27 inches. The growing season at 28 degrees F is 130 to 160 days, the frost-free season is 90 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Natapoc spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Natapoc stony sandy loam, 3 to 30 percent slopes, map unit 207 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Natapoc(revised 10/2001), established.
- Taxonomic class: Ashy over loamy-skeletal, glassy over isotic, frigid Typic Vitrixerands
- Rated with rule version 2026-09-28.1; the method is on the About page.