Nard soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 27 to 67 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nard soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Nard sandy loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 40 in (102 cm)).
- Note Typically starts about 27 in (68 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- Sandy layerH1 An ashy sandy loam layer about 0 to 7 in down: about 9% clay, low plasticity when wet, pale brown when moist. Weak indication
- Loamy layerH2 An ashy sandy loam layer about 7 to 27 in down: about 24% clay, moderate plasticity when wet, very pale brown when moist. Possible
- Loamy layerH3best layer A loam layer about 27 to 67 in down: about 27% clay, high plasticity when wet, light yellowish brown when moist. Possible
What it looks like raw
The loamy layer (H3), 27 to 67 in down in the typical profile: light yellowish brown (10YR 6/4), yellowish brown (10YR 5/4) moist; very hard, firm and brittle, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium from sandstone mixed with volcanic ash and loess.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in Kittitas and Chelan Counties; MLRA 6. This series is moderately extensive.
USDA, geographic setting: Nard soils are on north-facing hillslopes, foothills, dipslopes, mountains and terraces. Slopes are 0 to 65 percent. Nard soils formed in residuum and colluvium from Roslyn and Swauk sandstone and old alluvium with an influence of volcanic ash and loess in the surface. Elevations are 1,400 to 4,500 feet. The soils are in a semiarid climate with warm, dry summers and cool, moist winters. The mean annual precipitation is 20 to 40 inches. The average January temperature is about 24 degrees F. and the average July temperature is about 64 degrees F. The mean annual air temperature is 42 to 45 degrees F. The growing season at 28 degrees F is 145 to 175 days
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nard sandy loam, 3 to 30 percent slopes, map unit 200 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Nard(revised 09/2005), established.
- Taxonomic class: Fine-loamy, isotic, frigid Vitrandic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.