Mountaineer soil
Wild-clay potential
Weak indication
Weak indication: no layer of Mountaineer shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Mountaineer soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Mountaineer spot on the map
Rated from the USDA soil survey record for Mountaineer-Rock outcrop complex, 45 to 90 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 49% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A stony ashy sandy loam layer about 0 to 4 in down: about 8% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A very cobbly ashy sandy loam layer about 4 to 19 in down: about 8% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH3best layer An extremely stony sandy loam layer about 19 to 38 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 38 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 19 to 38 in down in the typical profile: yellowish brown (10YR 5/4), dark brown (10YR 3/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium from schist and gneiss mixed with volcanic ash and loess.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 38 in (96 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in West Central Chelan County; MLRA 6. This series is of small extent.
USDA, geographic setting: Mountaineer soils are on mountainsides and ridgetops with southerly aspects and have slopes of 30 to 90 percent. These soils formed in colluvium from schist or gneiss, mixed with volcanic ash. Many areas have been glaciated but little evidence of till is in the profile. Elevations are 1,400 to 4,800 feet. These soils are in a climate with warm dry summers and cool moist winters. The mean annual precipitation is 40 to 75 inches. The mean January temperature is about 22 degrees F.; the mean July temperature is about 64 degrees F.; the mean annual temperature is 41 to 44 degrees F.; growing season at 28 degrees F. is about 120 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Mountaineer spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Mountaineer-Rock outcrop complex, 45 to 90 percent slopes, map unit 196 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Mountaineer(revised 06/2011), established.
- Taxonomic class: Loamy-skeletal, isotic, frigid Andic Humixerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.