Metz soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 40 to 46 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Metz soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Metz loamy sand, moderately fine substratum (Orange County and Part of Riverside County, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Note Moderate thickness (about 6 in (15 cm)).
- Note Typically starts about 40 in (102 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA A loamy sand layer about 0 to 17 in down: about 5% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC1 A stratified sand to sandy clay loam layer about 17 to 40 in down: about 5% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerC2best layer A silty clay loam layer about 40 to 46 in down: about 30% clay, high plasticity when wet, light brownish gray when moist. Promising
- Sandy layerC3 A stratified sand to sandy clay loam layer about 46 to 60 in down: about 5% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The loamy layer (C2), 40 to 46 in down in the typical profile: light brownish gray (2.5Y 6/2), grayish brown (2.5Y 5/2) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium derived from igneous, metamorphic and sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in California, in these survey areas: Orange County and Part of Riverside County, California.
By state: wild clay in California.
USDA, distribution and extent: Coastal valleys of the central and south Coast Range of California, MLRA 14. The soils are of moderate extent.
USDA, geographic setting: Metz soils are on floodplains and alluvial fans at elevations of 25 to 2,500 feet. Gradient is 0 to 15 percent. The alluvium is derived from mixed but mostly sedimentary sources. The climate is dry mesothermal with warm dry summers and cool moist winters. Mean annual precipitation is 12 to 20 inches. The average January temperature is 47 to 50 degrees F; the average July temperature is 62 to 75 degrees F and the mean annual temperature is 57 to 60 degrees F. The average frost-free season is 175 to 340 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alo: Strong lead
- Bosanko: Strong lead
- Cropley: Strong lead
- Myford: Strong lead
- Omni: Strong lead
- Rincon: Strong lead
- Zaca: Strong lead
- Balcom: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Metz loamy sand, moderately fine substratum, map unit 164 in Orange County and Part of Riverside County, California.
- Official Series Description: Metz(revised 06/1999), established.
- Taxonomic class: Sandy, mixed, thermic Typic Xerofluvents
- Rated with rule version 2026-09-28.1; the method is on the About page.