McCree soil
Wild-clay potential
Weak indication
Weak indication: no layer of McCree shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about McCree soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for McCree stony fine sandy loam, 8 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 50% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A stony ashy fine sandy loam layer about 0 to 5 in down: about 10% clay, low plasticity when wet. Weak indication
- Sandy layerH2 A very stony ashy fine sandy loam layer about 5 to 19 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH3best layer An extremely stony sandy loam layer about 19 to 56 in down: about 9% clay, low plasticity when wet, yellow when moist. Weak indication
- BedrockH4 Unweathered bedrock about 56 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 19 to 56 in down in the typical profile: yellow (10YR 7/6), yellowish brown (10YR 5/6) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium from rhyolite or granodiorite, mixed with volcanic ash and pumice.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 56 in (142 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in east central Chelan County, Washington. This series is of moderate extent.
USDA, geographic setting: McCree soils are on mountain sides and ridgetops with southerly aspects and have slopes of 8 to 90 percent. These soils formed in colluvium mostly from rhyolite or granodiorite, mixed with volcanic ash and pumice in the upper part. Elevations are 2,300 to 5,300 feet. These soils are in a climate with warm, dry summers and cool, moist winters. The average annual precipitation is 20 to 30 inches. The mean January temperature is about 24 degrees F; the mean July temperature is about 64 degrees F; and the mean annual temperature is about 42 to 45 degrees F. The growing season at 28 degrees F is about 130 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for McCree stony fine sandy loam, 8 to 30 percent slopes, map unit 179 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: McCree(revised 01/2005), established.
- Taxonomic class: Loamy-skeletal, isotic, frigid Andic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.