Martinsville soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 24 to 40 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Martinsville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Martinsville spot on the map
Rated from the USDA soil survey record for Martinsville sandy loam, 0 to 2 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17.5).
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 9 in down: about 8% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBE A sandy loam layer about 9 to 18 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1 A sandy clay loam layer about 18 to 24 in down: about 26% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Clay subsoilBt2best layer A sandy clay loam layer about 24 to 40 in down: about 26% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerBC A sandy loam layer about 40 to 50 in down: about 18% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Sandy layer2C A stratified sand to silt loam to loam layer about 50 to 60 in down: about 10% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt2), 24 to 40 in down in the typical profile: brown (7.5YR 4/4); clay loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: Dominantly in MLRAs 97, 111A, 111B, 111C, and 111D in Indiana, southern Michigan, and western Ohio; and to a lesser extent in MLRA 95B, 108A, 108B, 110, 114B, 115A, 115C in Illinois. The type location is in MLRA 111D. The series is of large extent.
USDA, geographic setting: The Martinsville soils are on stream terraces, outwash plains, outwash terraces, and till plains. Slope ranges from 0 to 35 percent. The soils formed in as much as 51 cm (20 inches) of loess and in the underlying loamy outwash. Mean annual precipitation ranges from 762 to 1143 mm (30 to 45 inches). Mean annual temperature ranges from 7.2 to 13.0 degrees C (45 to 57 degrees F). Frost-free period is 130 to 210 days. Elevation is 110 to 305 meters (360 to 1,000 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Open a Martinsville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Martinsville sandy loam, 0 to 2 percent slopes, map unit MaA in Kosciusko County, Indiana.
- Official Series Description: Martinsville(revised 11/2021), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.