Lyme soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lyme shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lyme soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lyme fine sandy loam, 0 to 8 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 19% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 8 in down: about 2% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerBg1 A cobbly sandy loam layer about 8 to 13 in down: about 3% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBg2 A cobbly sandy loam layer about 13 to 26 in down: about 3% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layerBC A cobbly sandy loam layer about 26 to 31 in down: about 3% clay, low plasticity when wet, olive when moist. Weak indication
- Sandy layerCg A gravelly sandy loam layer about 31 to 42 in down: about 5% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layerCbest layer A gravelly sandy loam layer about 42 to 65 in down: about 5% clay, low plasticity when wet, olive when moist. Weak indication
What it looks like raw
The sandy layer (C), 42 to 65 in down in the typical profile: olive (5Y 5/3); gravelly sandy loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy supraglacial meltout till derived from phyllite and/or granite and gneiss and/or mica schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in New Hampshire, in these survey areas: Coos County Area, New Hampshire.
By state: wild clay in New Hampshire.
USDA, distribution and extent: Maine, New Hampshire, New York, and Vermont; MLRAs 143 and 144B. The series is of large extent.
USDA, geographic setting: Lyme soils are on nearly level to strongly sloping areas in slightly concave areas and shallow drainageways of glaciated uplands. The soils formed in late, Wisconsin aged melt-out till derived mainly from granite, gneiss, and schist. Slopes range from 0 to 15 percent. The Mean annual precipitation ranges from 790 to 1640 mm, and the mean annual soil temperature is 2 to 7 degrees C. The frost-free season ranges from 90 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abenaki: Weak indication
- Adams: Weak indication
- Becket: Weak indication
- Berkshire: Weak indication
- Bucksport: Weak indication
- Charles: Weak indication
- Cohas: Weak indication
- Colton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lyme fine sandy loam, 0 to 8 percent slopes, map unit 246B in Coos County Area, New Hampshire.
- Official Series Description: Lyme(revised 04/2025), established.
- Taxonomic class: Coarse-loamy, mixed, active, acid, frigid Aeric Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.