Lapwai soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lapwai shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lapwai soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lapwai-Bridgewater complex, 1 to 7 percent slopes (Lewis and Nez Perce Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 50% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 9 in down: about 15% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw1 A silt loam layer about 9 to 28 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw2 A loam layer about 28 to 35 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layer2Bkbest layer A very gravelly sandy loam layer about 35 to 60 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (2Bk), 35 to 60 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Lewis and Nez Perce Counties, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: North central Idaho. This soil is of small extent.
USDA, geographic setting: Lapwai soils are on stream terraces. Slopes range from 1 to 4 percent. These soils formed in loamy alluvium from mixed sources over gravelly alluvium predominantly from basalt. Elevations are 750 to 1,200 feet. Average annual precipitation is 16 to 20 inches, average annual temperature is 51 to 53 degrees F., and the frost free period is 160 to 185 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Taney: Strong lead
- Caldwell: Promising
- Latahco: Promising
- Naff: Promising
- Slickpoo: Promising
- Thatuna: Promising
- Almota: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lapwai-Bridgewater complex, 1 to 7 percent slopes, map unit 70 in Lewis and Nez Perce Counties, Idaho.
- Official Series Description: Lapwai(revised 10/2002), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.