Lacrescent soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lacrescent shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lacrescent soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lacrescent spot on the map
Rated from the USDA soil survey record for Lacrescent channery silt loam, 35 to 60 percent slopes (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 22 in (55 cm)).
- Note Typically starts about 38 in (97 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Loamy layerH1 A channery silt loam layer about 0 to 21 in down: about 24% clay, moderate plasticity when wet, black when moist. Weak indication
- Sandy layerH2 A very gravelly silt loam layer about 21 to 38 in down: about 16% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerH3best layer A very flaggy silt loam layer about 38 to 60 in down: about 16% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 38 to 60 in down in the typical profile: light olive brown (2.5Y 5/4); very friable. Raw colour is not fired colour.
About the soil
- Parent material: a mixture of loess and loamy colluvium over loamy-skeletal colluvial sediments from bedrock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Physiographic Division--Interior Plains
USDA, geographic setting: Parent material--12 to 50 centimeters of loess or a mixture of loess and loamy colluvium and in loamy-skeletal colluvial sediments from bedrock
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Open a Lacrescent spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lacrescent channery silt loam, 35 to 60 percent slopes, map unit 785G in Pike County, Illinois.
- Official Series Description: Lacrescent(revised 02/2011), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Typic Hapludolls
- Rated with rule version 2026-09-28.1; the method is on the About page.