Kloochman soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kloochman shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kloochman soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kloochman spot on the map
Rated from the USDA soil survey record for Kloochman gravelly fine sandy loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 16 in (40 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Lowers the potential High rock content (about 42% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly ashy fine sandy loam layer about 0 to 3 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly ashy fine sandy loam layer about 3 to 18 in down: about 8% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A very channery sandy loam layer about 18 to 34 in down: about 6% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 34 to 38 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 18 to 34 in down in the typical profile: light yellowish brown (10YR 6/4), yellowish brown (10YR 5/4) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum from gneiss and schist mixed with a mantle of volcanic ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 34 in (86 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in east central Chelan County, Washington. This series is of small extent.
USDA, geographic setting: Kloochman soils are on mountainsides and broad ridgetops and have slopes of 3 to 90 percent. Elevation is 2,500 to 5,000 feet. These soils formed in residuum and colluvium from gneiss or schist and volcanic ash. They are in a climate with warm, dry summers and cool, moist winters. The average annual precipitation is 25 to 35 inches. The mean January temperature is about 24 degrees F. The mean July temperature is about 64 degrees F; and the mean annual temperature is 41 to 45 degrees F. The frost-free season is 90 to 140 days. The growing season at 28 degrees F is 130 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Kloochman spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kloochman gravelly fine sandy loam, 3 to 30 percent slopes, map unit 152 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Kloochman(revised 01/2000), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Andic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.