Icicle soil
Wild-clay potential
Weak indication
Weak indication: no layer of Icicle shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Icicle soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Icicle very bouldery sandy loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 40 in (101 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Lowers the potential High rock content (about 48% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A very bouldery sandy loam layer about 0 to 5 in down: about 8% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2 An extremely cobbly sandy loam layer about 5 to 20 in down: about 8% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH3best layer An extremely cobbly sandy loam layer about 20 to 60 in down: about 6% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 20 to 60 in down in the typical profile: pale brown (10YR 6/3), yellowish brown (10YR 5/4) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from granite and granodiorite, or glacial till mixed with volcanic ash and loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in Chelan County. The series is of moderate extent.
USDA, geographic setting: Icicle soils are on mountain sides. Slopes range from 30 to 75 percent. These soils formed in colluvium from granitic rocks mixed with loess and volcanic ash. Most areas have been glaciated but little evidence of till is in the profile. Elevations are 1,500 to 5,000 feet. These soils are in a climate with warm, dry summers and cool, moist winters with a snowpack from December through March. The average annual precipitation is 28 to 50 inches. The average January temperature is about 24 degrees F, average July temperature is about 67 degrees F, and the average annual air temperature is 42 to 44 degrees F. The growing season at 28 degrees F is 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Icicle very bouldery sandy loam, 3 to 30 percent slopes, map unit 137 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Icicle(revised 01/2000), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Typic Dystroxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.