Gorham soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 10 to 40 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Gorham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Gorham silty clay loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 33% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (23): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 30 in (77 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silty clay loam layer about 0 to 10 in down: about 33% clay, high plasticity when wet, very dark gray when moist. Promising
- Loamy layerH2best layer A silty clay loam layer about 10 to 40 in down: about 33% clay, high plasticity when wet, dark gray when moist. Promising
- Loamy layerH3 A clay loam layer about 40 to 44 in down: about 31% clay, high plasticity when wet, olive brown when moist. Possible
- Sandy layerH4 A sand layer about 44 to 80 in down: about 5% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 10 to 40 in down in the typical profile: dark gray (10YR 4/1); very firm. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Flood plains of Mississippi, Illinois, and Ohio Rivers. Extent is small (about 8,800 acres) and is mainly in MLRA 115.
USDA, geographic setting: Gorham soils are on nearly level or gently undulating flood plains of major rivers. Slopes are typically 0 to 3 percent, but range to 7 percent. These soils formed in silty or loamy alluvium at least 40 inches thick. Below a depth of 40 inches the alluvium increases in sand content and decreases in clay content. These soils typically are subject to frequent flooding, but some areas are rare or occasional because of levees, locks and dams, or other flood-control structures. Mean annual temperature is 54 to 57 degrees F., mean annual precipitation is 36 to 44 inches, frost-free period is 180 to 210 days, and elevation is 340 to 450 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Gorham silty clay loam, 0 to 2 percent slopes, occasionally flooded, map unit 8162A in Pike County, Illinois.
- Official Series Description: Gorham, established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Fluvaquentic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.