Gilford soil
Wild-clay potential
Weak indication
Weak indication: no layer of Gilford shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Gilford soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Gilford spot on the map
Rated from the USDA soil survey record for Gilford sandy loam, till plain, 0 to 2 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 44 in (111 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 9% by volume).
- Note USDA reports about 13% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 11 in down: about 11% clay, low plasticity when wet. Weak indication
- Sandy layerBg A sandy loam layer about 11 to 30 in down: about 11% clay, moderate plasticity when wet, gray when moist. Weak indication
- Sandy layerBCg A loamy sand layer about 30 to 35 in down: about 6% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layerCgbest layer A sand layer about 35 to 79 in down: about 3% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (Cg), 35 to 79 in down in the typical profile: gray (10YR 6/1); loose. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy drift or outwash over sandy and gravelly outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 97, 98, 99, and 110, and LRUs 95B, 108A, 108B, 111B, 111C, and 115C in northern Indiana, Michigan, northwestern Ohio, southeastern Wisconsin, southeastern Iowa, northeastern Missouri, and northern and central Illinois. The series is of large extent.
USDA, geographic setting: Gilford soils are commonly in broad closed depressions on outwash plains, glacial drainage channels, near-shore zones (relict), and on flood-plain steps. Slope ranges from 0 to 2 percent. Gilford soils formed in loamy over sandy sediments. Mean annual precipitation ranges from 762 to 1067 mm (30 to 42 inches). Mean annual temperature ranges from 8.5 to 11.7 degrees C (48 to 53 degrees F). Frost-free period is 130 to 210 days. Elevation is 104 to 466 meters (340 to 1,530 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Open a Gilford spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Gilford sandy loam, till plain, 0 to 2 percent slopes, map unit GejA in Kosciusko County, Indiana.
- Official Series Description: Gilford(revised 11/2021), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Typic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.