Fountainville soil
Wild-clay potential
Weak indication
Weak indication: no layer of Fountainville shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fountainville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fountainville spot on the map
Rated from the USDA soil survey record for Fountainville silt loam, 0 to 3 percent slopes (Bucks County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "2Btx" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 21% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 8 in down: about 16% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Clay subsoilBt A silt loam layer about 8 to 22 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoil2Btxbest layer A channery silt loam layer about 22 to 46 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockR Bedrock about 46 to 56 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (2Btx), 22 to 46 in down in the typical profile: yellowish brown (10YR 5/4); firm and brittle, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
- Lithic bedrock typically about 46 in (117 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Pennsylvania, in these survey areas: Bucks County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania. The series is of moderate extent.
USDA, geographic setting: Fountainville soils are at heads of drains and along broad drainageways in the Northern piedmont Province. The soils are on summits and back slopes. They are formed in a thin mantle of loess and in the underlying material weathered from metamorphic and sedimentary brown and red shale, siltstone and sandstone residuum. Slope ranges from 0 to 15 percent. Mean annual precipitation is 42 to 45 inches. The mean annual air temperature is 45 to 63 degrees F. The frost-free days range from 155 to 190.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Amwell: Promising
- Bowmansville: Promising
- Croton: Promising
- Hatboro: Promising
- Lamington: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
See it on the map
Open a Fountainville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fountainville silt loam, 0 to 3 percent slopes, map unit FoA in Bucks County, Pennsylvania.
- Official Series Description: Fountainville, established.
- Taxonomic class: Fine-silty, mixed, active, mesic Oxyaquic Fragiudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.