Endicott soil
Wild-clay potential
Weak indication
Weak indication: no layer of Endicott shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Endicott soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Endicott spot on the map
Rated from the USDA soil survey record for Endicott-Bryden complex, 2 to 6 percent slopes (Lewis and Nez Perce Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (30 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilAbest layer A silt loam layer about 0 to 12 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw A silt loam layer about 12 to 20 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerBk A silt loam layer about 20 to 30 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerBkq A gravelly silt loam layer about 30 to 36 in down: about 13% clay, moderate plasticity when wet, the indurated layers are separated by grayish brown when moist. Weak indication
- Bkqm A cemented material layer about 36 to 60 in down: USDA gives no clay percentage or texture for it. Not enough data
What it looks like raw
The topsoil (A), 0 to 12 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess over colluvium derived from basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Lewis and Nez Perce Counties, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: East-central Washington and northwestern Idaho. The series is of moderate extent.
USDA, geographic setting: Endicott soils are on terraces, hills and plateaus at elevations of 900 to 3,500 feet. They formed in loess with a small amount of volcanic ash over a lime-silica cemented duripan. Slopes are 0 to 40 percent. The climate is semiarid with warm, dry summers and cool, moist winters. The mean annual precipitation is 12 to 16 inches. Average January temperature is about 29 degrees F, average July temperature is 71 degrees F. The mean annual temperature is 48 to 52 degrees F. The frost-free season is 110 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Taney: Strong lead
- Caldwell: Promising
- Latahco: Promising
- Naff: Promising
- Slickpoo: Promising
- Thatuna: Promising
- Almota: Possible
See it on the map
Open a Endicott spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Endicott-Bryden complex, 2 to 6 percent slopes, map unit 37 in Lewis and Nez Perce Counties, Idaho.
- Official Series Description: Endicott(revised 11/2008), established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Haplic Durixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.