Elizabeth soil
Wild-clay potential
Weak indication
Weak indication: no layer of Elizabeth shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Elizabeth soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Elizabeth spot on the map
Rated from the USDA soil survey record for Elizabeth very channery silt loam, 35 to 60 percent slopes (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 28% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A very channery silt loam layer about 0 to 4 in down: about 23% clay, moderate plasticity when wet, very dark gray when moist. Weak indication
- Loamy layerH2best layer A flaggy silt loam layer about 4 to 16 in down: about 21% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- BedrockR3 Bedrock about 16 to 26 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 4 to 16 in down in the typical profile: dark brown (10YR 3/3); friable. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 16 in (41 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Physiographic Division--Interior Plains
USDA, geographic setting: Elizabeth soils are on gently sloping to very steep ridges and side slopes on uplands. Slope ranges from 4 to 65 percent. Elizabeth soils formed in 18 to 51 cm (7 to 20 inches) of loamy material weathered from dolomitic limestone. The mean annual precipitation ranges from 737 to 914 mm (29 to 36 inches), and mean annual air temperature 8.9 to 12.2 degrees C (48 to 54 degrees F). Elevation ranges from 180 to 430 meters (590 to 1410 feet) above mean sea level. Frost-free period ranges from 145 to 180 days.days
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Open a Elizabeth spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Elizabeth very channery silt loam, 35 to 60 percent slopes, map unit 403G in Pike County, Illinois.
- Official Series Description: Elizabeth(revised 01/2015), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Lithic Hapludolls
- Rated with rule version 2026-09-28.1; the method is on the About page.