Dynal soil
Wild-clay potential
Weak indication
Weak indication: no layer of Dynal shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dynal soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Dynal sand, 2 to 15 percent slopes (Tooele Area, Utah - Tooele County and Parts of Box Elder, Davis and Juab Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 1% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 59 in (149 cm)).
- Note Typically starts within about 1 in (3 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 65% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A sand layer about 0 to 1 in down: about 1% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH2best layer A sand layer about 1 to 60 in down: about 1% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (H2), 1 to 60 in down in the typical profile: light gray (10YR 7/2), light gray (10YR 7/2) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: calcareous, oolitic, eolian sand derived from lacustrine sediments.
- USDA family mineralogy: carbonatic (lime-rich).
- USDA family particle-size class: not used.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Tooele Area, Utah - Tooele County and Parts of Box Elder, Davis and Juab Counties.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah along the Great Salt Lake. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Dynal soils are on slightly elevated beach ridges and stable dunes along the edge of the Great Salt Lake. They formed in beach sand and eolian sands derived mainly from oolites (ooliths). Oolites are small, rounded, sand-sized accretionary bodies formed of concentric layers of calcium carbonate around a sand-sized nucleus of mineral or organic origin and formed in wave-agitated waters. Mineral grains derived from metamorphic and sedimentary rocks are also a component of the soil parent material. Slopes are 2 to 15 percent and are both concave and convex. Elevation ranges from 4,200 to 4,250 feet. The mean annual precipitation is 6 to 8 inches, the mean annual temperature is 48 to 52...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Logan: Promising
- Birdow: Possible
- Broad: Weak indication
- Kilburn: Weak indication
- Ridd: Weak indication
- Abbott: Strong lead(same state)
- Airport: Strong lead(same state)
- Ant Flat: Strong lead(same state)
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dynal sand, 2 to 15 percent slopes, map unit 17 in Tooele Area, Utah - Tooele County and Parts of Box Elder, Davis and Juab Counties.
- Official Series Description: Dynal(revised 11/2005), established.
- Taxonomic class: Carbonatic, mesic Typic Torripsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.