Duncannon soil
Wild-clay potential
Weak indication
Weak indication: no layer of Duncannon shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Duncannon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Duncannon spot on the map
Rated from the USDA soil survey record for Duncannon silt loam, 0 to 3 percent slopes (Bucks County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 17% clay.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Lowers the potential Low engineering plasticity index (4): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 15% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtbest layer A silt loam layer about 10 to 45 in down: about 17% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layer2C A channery silt loam layer about 45 to 68 in down: about 17% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 45 in down in the typical profile: brown (7.5YR 4/4); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
- Lithic bedrock typically about 80 in (202 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Pennsylvania, in these survey areas: Bucks County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, western West Virginia, and southeastern Ohio. It is of moderate extent.
USDA, geographic setting: These soils are on nearly level to moderately steep uplands and terraces. The soils formed in silty to very fine sandy loam material, presumed to be eolian, overlying a variety of materials of shale, sandstone, limestone, schist, stream deposits and glacial deposits. Slope ranges from 0 to 35 percent. Climate is continental with warm summers and cold winters. Rainfall averages 35 to 48 inches and is evenly distributed throughout the year. Average annual air temperature is 50 degrees to 60 degrees F. and the frost free season is 150 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Amwell: Promising
- Bowmansville: Promising
- Croton: Promising
- Hatboro: Promising
- Lamington: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
See it on the map
Open a Duncannon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Duncannon silt loam, 0 to 3 percent slopes, map unit DuA in Bucks County, Pennsylvania.
- Official Series Description: Duncannon(revised 02/2004), established.
- Taxonomic class: Coarse-silty, mixed, active, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.