Duane soil
Wild-clay potential
Weak indication
Weak indication: no layer of Duane shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Duane soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Duane fine sandy loam, 0 to 5 percent slopes (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 32 in (82 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Lowers the potential High rock content (about 48% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 6 in down: about 3% clay, low plasticity when wet, reddish gray when moist. Weak indication
- Sandy layerH2best layer A very gravelly loamy sand layer about 6 to 38 in down: about 3% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerH3 A coarse sand layer about 38 to 52 in down: about 2% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 6 to 38 in down in the typical profile: dark reddish brown (5YR 3/4); firm. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly glaciofluvial deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Vermont, in these survey areas: Addison County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: Northern parts of New York, Vermont, New Hampshire and Maine. Possibly northern Michigan, Wisconsin, and Minnesota. The soils are of moderate extent.
USDA, geographic setting: Duane soils are on nearly level and locally low areas of outwash terraces. Slopes are mainly less than 3 percent in gradient. The water table fluctuates to within less than two feet of the surface. The soils formed in glacial outwash sand and gravel derived mainly from sandstone, granite and gneiss. Mean annual temperature ranges from 38 degrees to 44 degrees F.; mean annual precipitation from 35 to 50 inches; and mean frost-free season from 90 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Covington: Strong lead
- Livingston: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Elmwood: Promising
- Canandaigua: Possible
- Farmington: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Duane fine sandy loam, 0 to 5 percent slopes, map unit DaA in Addison County, Vermont.
- Official Series Description: Duane(revised 12/2021), established.
- Taxonomic class: Sandy-skeletal, mixed, frigid, ortstein Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.