Drury soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 43 to 80 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Drury soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Drury silt loam, 2 to 5 percent slopes, rarely flooded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12).
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts about 43 in (109 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 7 in down: about 20% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH2 A silt loam layer about 7 to 43 in down: about 22% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Loamy layerH3best layer A silt loam layer about 43 to 80 in down: about 18% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
What it looks like raw
The loamy layer (H3), 43 to 80 in down in the typical profile: dark yellowish brown (10YR 4/4); very friable. Raw colour is not fired colour.
About the soil
- Parent material: local silty alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Illinois. These soils are small in extent in MLRAs 108B, 114B, 115A, 115B and 115C. The type location is in MLRA 115B.
USDA, geographic setting: Drury soils are on the foot slopes of steep river bluffs adjacent to flood plains of major streams, and less commonly on stream terraces where currently there is little or no deposition of alluvium. Slopes commonly are 2 to 10 percent but range between 0 and 30 percent. Drury soils formed in silty local alluvial sediments, and less commonly in silty outwash. Mean annual temperature ranges from 47 to 57 degrees F (8 to 14 degrees C), and mean annual precipitation ranges from 34 to 48 inches (864 to 1219 mm). Frost free days range from 170 to 200 days. Elevation ranges from 340 to 700 feet (104 to 213 meters) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 94%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Drury silt loam, 2 to 5 percent slopes, rarely flooded, map unit 7075B in Pike County, Illinois.
- Official Series Description: Drury(revised 03/2007), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Dystric Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.