Dozaville soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 18 to 59 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dozaville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Dozaville spot on the map
Rated from the USDA soil survey record for Dozaville silt loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Illinois) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 41 in (105 cm)).
- Note Typically starts within about 18 in (45 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 18 in down: about 22% clay, moderate plasticity when wet, very dark brown when moist. Possible
- Loamy layerH2best layer A silt loam layer about 18 to 59 in down: about 21% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Sandy layerH3 A silt loam layer about 59 to 80 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 18 to 59 in down in the typical profile: dark yellowish brown (10YR 4/4); very friable. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Illinois, in these survey areas: Pike County, Illinois.
By state: wild clay in Illinois.
USDA, distribution and extent: Illinois in the major river valleys. Extent is small, and mainly in MLRA 115B and MLRA 115C.
USDA, geographic setting: Dozaville soils are on flood plains. They formed dominantly in silty alluvium that becomes sandy with increasing depth below the particle-size control section. Slopes commonly are 0 to 2 percent but range to as steep as 5 percent. These soils typically are subject to frequent flooding, but flooding frequency in some areas is occasional or rare because of levees, locks and dams, or other flood-control structures. Mean annual temperature is 54 to 57 degrees F., mean annual precipitation is 36 to 44 inches, frost-free period is 170 to 210 days, and elevation is 350 to 550 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Darwin: Strong lead
- Elco: Strong lead
- Ipava: Strong lead
- Keswick: Strong lead
- Titus: Strong lead
- Ambraw: Promising
- Baylis: Promising
- Beaucoup: Promising
See it on the map
Open a Dozaville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dozaville silt loam, 0 to 2 percent slopes, occasionally flooded, map unit 8674A in Pike County, Illinois.
- Official Series Description: Dozaville(revised 04/2001), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Fluventic Hapludolls
- Rated with rule version 2026-09-28.1; the method is on the About page.