Downer soil
Wild-clay potential
Weak indication
Weak indication: no layer of Downer shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Downer soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Downer loamy sand, 5 to 10 percent slopes, Northern Coastal Plain (Salem County, New Jersey) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 32 in (81 cm)).
- Lowers the potential Typically starts about 48 in (122 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilAp A loamy sand layer about 0 to 9 in down: about 3% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBE A loamy sand layer about 9 to 16 in down: about 5% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt A sandy loam layer about 16 to 28 in down: about 14% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerC1 A loamy sand layer about 28 to 48 in down: about 3% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerC2best layer A sand layer about 48 to 80 in down: about 5% clay, low plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 48 to 80 in down in the typical profile: yellowish brown (10YR 5/6); loose. Raw colour is not fired colour.
About the soil
- Parent material: loamy fluviomarine deposits.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 13 map units in Maryland, New Jersey, Virginia, in these survey areas: Cecil County, Maryland; Fairfax County, Virginia; Prince George's County, Maryland; Salem County, New Jersey.
By state: wild clay in Maryland,wild clay in New Jersey,wild clay in Virginia.
USDA, distribution and extent: Distribution: The Northern Coastal Plain of New Jersey, Delaware, and Maryland
USDA, geographic setting: Landscape: Northern Atlantic Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Gunston: Strong lead
- Howell: Strong lead
- Lunt: Strong lead
- Magnolia: Strong lead
- Montalto: Strong lead
- Orange: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Downer loamy sand, 5 to 10 percent slopes, Northern Coastal Plain, map unit DocC in Salem County, New Jersey.
- Official Series Description: Downer(revised 01/2012), established.
- Taxonomic class: Coarse-loamy, siliceous, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.