Domkey soil
Wild-clay potential
Weak indication
Weak indication: no layer of Domkey shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Domkey soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Domkey sandy loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 18% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 An ashy sandy loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 An ashy sandy loam layer about 3 to 10 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH3 A gravelly ashy sandy loam layer about 10 to 18 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerH4best layer A gravelly ashy coarse sandy loam layer about 18 to 35 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH5 A very gravelly loamy coarse sand layer about 35 to 45 in down: about 8% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- BedrockH6 Weathered bedrock about 45 to 55 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H4), 18 to 35 in down in the typical profile: pale brown (10YR 6/3), dark grayish brown (10YR 4/2) moist; soft, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and pumice over residuum weathered from granodiorite.
- USDA family particle-size class: ashy over sandy or sandy-skeletal.
- Drainage: well drained.
- Paralithic bedrock typically about 45 in (114 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: North-central Washington, Chelan County. Series is of small extent.
USDA, geographic setting: Domkey soils are on back slopes of mountains that commonly have a northerly aspect. Elevation is 1,200 to 4,500 feet. Slopes are 5 to 60 percent. Domkey soils formed in volcanic ash and pumice over weathered granodiorite. The climate is characterized by warm, dry summers and cool, moist winters. The average annual precipitation is 18 to 25 inches. The average January temperature is about 28 degrees F, the average July temperature is about 68 degrees F, and the average annual air temperature is 42 to 44 degrees F. The growing season, at 28 degrees F, is 130 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Domkey sandy loam, 30 to 60 percent slopes, map unit 98 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Domkey(revised 07/2004), established.
- Taxonomic class: Ashy over sandy or sandy-skeletal, glassy over isotic, frigid Typic Vitrixerands
- Rated with rule version 2026-09-28.1; the method is on the About page.