Dinkels soil
Wild-clay potential
Weak indication
Weak indication: no layer of Dinkels shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dinkels soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Dinkels spot on the map
Rated from the USDA soil survey record for Dinkels gravelly sandy loam, 45 to 70 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 34% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly ashy sandy loam layer about 0 to 11 in down: about 11% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly sandy loam layer about 11 to 22 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A gravelly coarse sandy loam layer about 22 to 59 in down: about 6% clay, low plasticity when wet, pale brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 59 to 63 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 22 to 59 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium from granodiorite mixed with loess and volcanic ash.
- USDA family particle-size class: ashy.
- Drainage: well drained.
- Lithic bedrock typically about 59 in (150 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: North central Washington; MLRA 8 . The series is of small extent.
USDA, geographic setting: Dinkels soils are on side slopes of plateaus and mountain side slopes that generally have a northerly aspect. Slopes are 5 to 70 percent. These soils formed in colluvium from granite, granodiorite and gneiss mixed with loess, volcanic ash and pumice. Elevations are 700 to 3,000 feet. These soils are in a climate with warm, dry summers and cool, moist winters. The mean annual precipitation is l2 to 18 inches. The average January temperature is about 24 degrees F. and the average July temperature is about 69 degrees F, The mean annual air temperature is about 46 degrees F. The frost-free season is 90 to l55 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Dinkels spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dinkels gravelly sandy loam, 45 to 70 percent slopes, map unit 96 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Dinkels(revised 07/2004), established.
- Taxonomic class: Ashy, glassy, mesic Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.