Dinkelman soil
Wild-clay potential
Weak indication
Weak indication: no layer of Dinkelman shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dinkelman soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Dinkelman spot on the map
Rated from the USDA soil survey record for Dinkelman gravelly sandy loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 23% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly ashy sandy loam layer about 0 to 15 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2best layer A gravelly sandy loam layer about 15 to 42 in down: about 10% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- BedrockH3 Weathered bedrock about 42 to 52 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 15 to 42 in down in the typical profile: light yellowish brown (10YR 6/4), brown (10YR 4/3) moist; slightly hard, friable, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum from granodiorite mixed with some volcanic ash and loess.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 42 in (107 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties; Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: North-central Washington; MLRA 6. The series is of moderate extent.
USDA, geographic setting: Dinkelman soils are on mountain side slopes at elevations of 1,800 to 3,700 feet. Most have north or east aspect. The slopes range from 0 to 90 percent. These soils formed in material weathered from granitic rock with volcanic ash influence. Some pedons contain some rounded glacial gravel. These soils are in a climate with warm, dry summers and cool, moist winters. The mean January temperature is about 24 degrees F. and the mean July temperature is about 65 degrees F. The mean annual temperature is about 44 degrees F. The mean annual precipitation is 15 to 24 inches. The frost-free season is 90 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
See it on the map
Open a Dinkelman spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dinkelman gravelly sandy loam, 30 to 60 percent slopes, map unit 91 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Dinkelman(revised 07/2004), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.