Covello soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 51 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Covello soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Covello spot on the map
Rated from the USDA soil survey record for Covello silt loam (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 9 in (22 cm)).
- Lowers the potential Typically starts about 51 in (130 cm) down, deeper than most hand digging.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 7 in down: about 14% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 7 to 51 in down: about 17% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH3best layer A silty clay loam layer about 51 to 60 in down: about 30% clay, high plasticity when wet, dark gray when moist. Possible
What it looks like raw
The loamy layer (H3), 51 to 60 in down in the typical profile: dark gray (10YR 4/1), gray (10YR 6/1) dry; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium from loess and ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Whitman County, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Southeastern Washington. The series is of small extent.
USDA, geographic setting: Nearly level bottom lands along streams, at an elevation of 1,200 to 2,100 feet. The soils are frequently flooded when streams are high. They formed in alluvium consisting mainly of loess and volcanic ash. Summers are hot and dry, and winters are cool and moist. Annual precipitation is 16 to 23 inches. Average January temperature is 32 degrees F., average July temperature is 71 degrees F., mean annual temperature is 51 degrees F. ASSOCIATED SOILS: These are the competing Hermiston and Mondovi soils and the Athena, Patit Creek, and Palouse soils. Athena and Palouse soils have a cambic horizon, and occupy upland positions. Patit Creek soils have more than 15 percent coarser than very fine...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
- Naff: Promising
- Spofford: Promising
- Thatuna: Promising
See it on the map
Open a Covello spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Covello silt loam, map unit 31 in Whitman County, Washington.
- Official Series Description: Covello(revised 10/2002), established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.