Colvard soil
Wild-clay potential
Weak indication
Weak indication: no layer of Colvard shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Colvard soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Colvard spot on the map
Rated from the USDA soil survey record for Colvard fine sandy loam, 0 to 2 percent slopes, frequently flooded (Fauquier County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 43 in (109 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilH1 A fine sandy loam layer about 0 to 17 in down: about 9% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2best layer A fine sandy loam layer about 17 to 60 in down: about 9% clay, low plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 17 to 60 in down in the typical profile: yellowish brown (10YR 5/6); very friable. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from igneous and metamorphic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Fauquier County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Flood plains of the southern Appalachian Mountains of Georgia, North Carolina, South Carolina, Tennessee, and Virginia. The series is of moderate extent.
USDA, geographic setting: Colvard soils are on flood plains of mountain valleys in the southern Appalachian Mountains. Slopes range from 0 to 4 percent. The soils formed in loamy and sandy sediments. The mean annual air temperature ranges from 46 to 57 degrees F., and the mean annual precipitation ranges from 38 to 65 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Fletcherville: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
See it on the map
Open a Colvard spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Colvard fine sandy loam, 0 to 2 percent slopes, frequently flooded, map unit 1A in Fauquier County, Virginia.
- Official Series Description: Colvard(revised 04/2001), established.
- Taxonomic class: Coarse-loamy, mixed, active, nonacid, mesic Typic Udifluvents
- Rated with rule version 2026-09-28.1; the method is on the About page.