Coloma soil
Wild-clay potential
Weak indication
Weak indication: no layer of Coloma shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Coloma soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Coloma loamy sand, 0 to 6 percent slopes, fine-loamy minor components (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 46 in (118 cm)).
- Note Typically starts about 33 in (85 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilAp A loamy sand layer about 0 to 9 in down: about 4% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw A sand layer about 9 to 33 in down: about 3% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerE and Btbest layer A sand layer about 33 to 80 in down: about 2% clay, low plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The sandy layer (E and Bt), 33 to 80 in down in the typical profile: strong brown (7.5YR 5/6); very friable. Raw colour is not fired colour.
About the soil
- Parent material: sandy outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: not used.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 89, 96, 97, 98, 104, 105, and LRUs 95A, 95B, 108A, 108B, 111B, 111C, 111D, and 115C in central and southern Wisconsin, northern Indiana, Illinois, southeastern Minnesota, northeastern Iowa, southern Michigan, and Ohio. This series is of large in extent.
USDA, geographic setting: Coloma soils are on moraines, outwash plains, deltas, and stream terraces. Slope ranges from 0 to 70 percent. These soils formed in sandy drift. Mean annual precipitation ranges from 711 to 1040 mm (28 to 41 inches). Mean annual air temperature ranges from 7.8 to 10.6 degrees C (46 to 51 degrees F). The frost-free period is 135 to 200 days. Elevation is 183 to 427 meters (600 to 1400 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Coloma loamy sand, 0 to 6 percent slopes, fine-loamy minor components, map unit ClB in Kosciusko County, Indiana.
- Official Series Description: Coloma(revised 12/2015), established.
- Taxonomic class: Mixed, mesic Lamellic Udipsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.