Chumstick soil
Wild-clay potential
Weak indication
Weak indication: no layer of Chumstick shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Chumstick soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Chumstick spot on the map
Rated from the USDA soil survey record for Chumstick stony sandy loam, 3 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential High rock content (about 38% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A stony sandy loam layer about 0 to 4 in down: about 6% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2best layer A very stony sandy loam layer about 4 to 14 in down: about 6% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 An extremely stony sandy loam layer about 14 to 19 in down: about 6% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 19 to 23 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 4 to 14 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum from granite, gneiss, and schist mixed with volcanic ash and loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 19 in (48 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in north and central Washington. Series is of moderate extent.
USDA, geographic setting: Chumstick soils are on mountainsides that generally have a southerly aspect. Slopes range from 3 to 90 percent. These soils formed in colluvium and residuum from schist, gneiss, and granitic rock mixed with volcanic ash and loess. Elevation is 1,500 to 5,800 feet. The climate is characterized by warm, dry summers and cold, moist winters. The average annual precipitation is 18 to 32 inches. The mean January temperature is about 24 degrees F; mean July temperature is about 62 degrees F; and the mean annual air temperature is about 43 degrees F. The frost-free period is 90 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Chumstick spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Chumstick stony sandy loam, 3 to 30 percent slopes, map unit 76 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Chumstick(revised 06/2005), established.
- Taxonomic class: Loamy-skeletal, isotic, frigid Lithic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.