Chapot soil
Wild-clay potential
Weak indication
Weak indication: no layer of Chapot shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Chapot soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Chapot extremely bouldery loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 32% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 44 in (111 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Lowers the potential High rock content (about 44% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Loamy layerH1 An extremely bouldery loam layer about 0 to 8 in down: about 19% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerH2 A very stony loam layer about 8 to 16 in down: about 23% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH3best layer A very bouldery clay loam layer about 16 to 60 in down: about 32% clay, moderate plasticity when wet, brownish yellow when moist. Weak indication
What it looks like raw
The loamy layer (H3), 16 to 60 in down in the typical profile: brownish yellow (10YR 6/6), dark yellowish brown (10YR 4/4) moist; hard, very firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium from basalt with a minor amount of volcanic ash and mass movement deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in Chelan and Kittitas Counties, Washington. The series is moderately extensive.
USDA, geographic setting: Chapot soils are on back slopes of mountains at elevations of 2,000 to 4,900 feet. Slopes range from 30 to 60 percent slopes. Chapot soils formed in residuum and colluvium from basalt with a minor amount of volcanic ash. They are in a climate of warm, dry summers and cool, moist winter. The mean January temperature is about 23 degrees F., the mean July temperature is about 63 degrees F., and the mean annual temperature is 40 to 45 degrees F. The average annual precipitation is 22 to 40 inches. The growing season at 28 degrees F is 135 to 180 days. The frost-free season is 85 to 125 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Chapot extremely bouldery loam, 30 to 60 percent slopes, map unit 58 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Chapot(revised 01/2001), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Ultic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.