Buckland soil
Wild-clay potential
Weak indication
Weak indication: no layer of Buckland shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Buckland soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Buckland spot on the map
Rated from the USDA soil survey record for Buckland loam, 3 to 15 percent slopes, very stony (Addison County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 44 in (112 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA A loam layer about 1 to 7 in down: about 10% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerBw1 A very fine sandy loam layer about 7 to 15 in down: about 7% clay, low plasticity when wet, dark olive brown when moist. Weak indication
- Sandy layerBw2 A very fine sandy loam layer about 15 to 21 in down: about 7% clay, low plasticity when wet, olive brown when moist. Weak indication
- Sandy layerCdbest layer A very fine sandy loam layer about 21 to 65 in down: about 7% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (Cd), 21 to 65 in down in the typical profile: very dark grayish brown (2.5Y 3/2); loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy lodgment till derived from mica schist and/or loamy lodgment till derived from limestone and/or loamy lodgment till derived from phyllite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Vermont, in these survey areas: Addison County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: MLRAs 143 and 144B in Vermont, Massachusetts, and New York. The soils of this series are of moderate extent.
USDA, geographic setting: Buckland soils are nearly level to steep soils on hills in glaciated uplands. Slope ranges from 0 to 60 percent. The soils formed in dark colored lodgment till derived mainly from phyllite and schist. Small amounts of limestone have contributed to the character of the till in places. The mean annual precipitation is 910 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost free period is from 70 to 135 days. Elevations range from 100 to 700 meters above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Covington: Strong lead
- Livingston: Strong lead
- Melrose: Strong lead
- Swanton: Strong lead
- Vergennes: Strong lead
- Elmwood: Promising
- Canandaigua: Possible
- Farmington: Possible
See it on the map
Open a Buckland spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 84%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Buckland loam, 3 to 15 percent slopes, very stony, map unit BuC in Addison County, Vermont.
- Official Series Description: Buckland(revised 04/2025), established.
- Taxonomic class: Coarse-loamy, mixed, semiactive, frigid Aquic Humudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.