Bronson soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bronson shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bronson soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bronson spot on the map
Rated from the USDA soil survey record for Bronson sandy loam, 0 to 2 percent slopes (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Note USDA labels this a "Bt3,Bt4" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 9 in down: about 6% clay, low plasticity when wet. Weak indication
- Sandy layerBE A sandy loam layer about 9 to 17 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt1 A sandy loam layer about 17 to 24 in down: about 15% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Clay subsoilBt2 A sandy loam layer about 24 to 32 in down: about 15% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Clay subsoilBt3,Bt4best layer A loamy sand layer about 32 to 59 in down: about 7% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layer2C A gravelly coarse sand layer about 59 to 70 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3,Bt4), 32 to 59 in down in the typical profile: yellowish brown (10YR 5/4); very friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy outwash over sandy and gravelly outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 97, 98, 99, 111B, and 111C in southern Michigan and northern Indiana. The series is of moderate extent.
USDA, geographic setting: Bronson soils are on outwash plains, valley trains, and low-lying moraines. Slope ranges from 0 to 7 percent. Bronson soils formed in loamy and sandy materials overlying loamy sand or gravelly sand deposits. Mean annual precipitation ranges from 762 to 1067 mm (30 to 42 inches). Mean annual temperature ranges from 8.9 to 11.7 degrees C (48 to 53 degrees F). Frost-free period is 130 to 170 days. Elevation is 177 to 311 meters (580 to 1020 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Open a Bronson spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bronson sandy loam, 0 to 2 percent slopes, map unit BrA in Kosciusko County, Indiana.
- Official Series Description: Bronson(revised 02/2014), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.