Brief soil
Wild-clay potential
Weak indication
Weak indication: no layer of Brief shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brief soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Brief gravelly sandy loam, 0 to 15 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 39% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 16 in down: about 9% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly sandy loam layer about 16 to 26 in down: about 9% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A very gravelly coarse sandy loam layer about 26 to 60 in down: about 9% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 26 to 60 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived mainly from granodiorite, gneiss and schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties; Chelan County Area, Washington (Parts of Chelan and Kittitas Counties).
By state: wild clay in Washington.
USDA, distribution and extent: North-central Washington. Series is of moderate extent.
USDA, geographic setting: Brief soils are on alluvial fans and terraces. Slopes are 0 to 25 percent. Elevation is 900 to 1,500 feet. These soils formed in alluvium. The climate is warm and dry in summer and cool and moist winters. Average annual precipitation is 15 to 18 inches. Average January temperature is about 27 degrees F., average July temperature is about 67 degrees F., and mean annual air temperature is 46 to 48 degrees F. The frost-free season is 120 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Peoh: Promising
- Cowiche: Possible
- Morical: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brief gravelly sandy loam, 0 to 15 percent slopes, map unit 50 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Brief(revised 10/2002), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Typic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.