Blag soil
Wild-clay potential
Weak indication
Weak indication: no layer of Blag shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Blag soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Blag-Cle Elum-Rock outcrop complex, 30 to 75 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 17% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 6 in down: about 8% clay, low plasticity when wet. Weak indication
- Sandy layerH2best layer A gravelly sandy loam layer about 6 to 16 in down: about 8% clay, low plasticity when wet. Weak indication
- BedrockH3 Unweathered bedrock about 16 to 20 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 6 to 16 in down in the typical profile: soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
- Lithic bedrock typically about 16 in (41 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East slopes of the Cascade Mountains in southern Chelan and northern Kittitas Counties. The series is of small extent.
USDA, geographic setting: Blag soils are on mountainsides that generally have a southerly aspect. Slopes range from 30 to 80 percent. These soils formed in residuum and colluvium derived primarily from sandstone of the Chumstick formation. Elevations are l,500 to 4,000 feet. These soils are in a climate with warm dry summers and cool moist winters with a snow pack from about December to March. The average annual precipitation is 18 to 28 inches. The average January temperature is about 26 degrees F., average July temperature is about 67 degrees F., and the average annual air temperature is 45 to 47 degrees F. The growing season at 28 degrees F is l60 to l85 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Blag-Cle Elum-Rock outcrop complex, 30 to 75 percent slopes, map unit 45 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Blag(revised 06/1999), established.
- Taxonomic class: Loamy, mixed, superactive, mesic Lithic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.