Bisping soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bisping shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bisping soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bisping spot on the map
Rated from the USDA soil survey record for Bisping fine sandy loam, 3 to 15 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 4 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A paragravelly ashy fine sandy loam layer about 4 to 30 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH3best layer A loam layer about 30 to 60 in down: about 15% clay, low plasticity when wet, brownish yellowish when moist. Weak indication
What it looks like raw
The sandy layer (H3), 30 to 60 in down in the typical profile: brownish yellowish (10YR 6/6), dark yellowish brown (10YR 4/4) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and pumice over residuum and colluvium weathered from granodiorite and rhyolite.
- USDA family particle-size class: ashy over loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East Central Chelan County, Washington. This series of small extent.
USDA, geographic setting: Bisping soils are on broad ridgetops and mountainsides at elevations of 2,200 to 3,500 feet. Slopes are 3 to 60 percent. These soils formed in volcanic ash and cinders over material weathered from granodiorite or rhyolite. They are in a climate with warm, dry summers and cool, moist winters. The mean annual precipitation is about 18 to 30 inches; the mean annual temperature is about 45 to 47 degrees F. The growing season at 28 degrees F is about 160 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Bisping spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bisping fine sandy loam, 3 to 15 percent slopes, map unit 40 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Bisping(revised 05/2001), established.
- Taxonomic class: Ashy over loamy, glassy over isotic, mesic Humic Vitrixerands
- Rated with rule version 2026-09-28.1; the method is on the About page.