Barry soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 15 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Barry soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Barry loam (Kosciusko County, Indiana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 8 in down: about 18% clay, moderate plasticity when wet. Weak indication
- TopsoilA A loam layer about 8 to 15 in down: about 13% clay, moderate plasticity when wet, gray when moist. Weak indication
- Loamy layerBg1,Bg2,Bg3best layer A sandy clay loam layer about 15 to 50 in down: about 21% clay, moderate plasticity when wet, brown when moist. Possible
- Sandy layerC A loam layer about 50 to 60 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (Bg1,Bg2,Bg3), 15 to 50 in down in the typical profile: brown (10YR 5/3); friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Indiana, in these survey areas: Kosciusko County, Indiana.
By state: wild clay in Indiana.
USDA, distribution and extent: MLRAs 95B, 97, 98, 99, 103, 111B, and 111C in southern Michigan, southeastern Wisconsin, southern Minnesota, and northern Indiana. The series is of large extent.
USDA, geographic setting: Barry soils are on nearly level and depressional areas of ground moraines end moraines, and till plains. Slope ranges from 0 to 3 percent. The Barry soils formed in loamy till. Mean annual precipitation ranges from 660 to 940 mm (26 to 37 in). Mean annual temperature ranges from 8.3 to 10.0 degrees C (47 to 50 degrees F).
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Del Rey: Strong lead
- Saranac: Strong lead
- Toledo: Strong lead
- Aubbeenaubbee: Promising
- Crosier: Promising
- Metea: Promising
- Miami: Promising
- Rensselaer: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Barry loam, map unit Bc in Kosciusko County, Indiana.
- Official Series Description: Barry(revised 02/2017), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Typic Argiaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.